Storix-software SBAdmin TSM Edition Users Guide Bedienungsanleitung PDF herunterladen (Seite 47)

Storix System Backup Administrator 47 Version 8.2 TSM Edition User Guide

1. Select Configure!Backup Jobs or Actions!Run a Backup Job from the menu bar, then select the Job

ID at the top o the screen and press the Run Now button.

2. If the

Job Information is displayed on the Main Screen, select the icon for the job to run and press the

Run button at the bottom of the screen.

3. If the job is currently at the top of a

job queue but is not running because it had previously failed or was

placed on hold, display the job queues on the Main Screen, select the queue in which the job is placed,

and then press the Restart button.

For the first two options, "running" the job actually just places the job in the

job queue. If there are no other jobs

in the same queue, the job will start running immediately. If another job is running to the same device, this job

will be placed in a “Pending” state until the prior job finishes. If a prior job had failed, it will remain in the queue

and block other jobs from starting. The failed job must therefore be either restarted or removed from the queue

to allow jobs behind it to start.

Adding a Job to the Queue from the Command Line

Even if the SBAdmin Interface is not running, scheduled jobs will automatically be placed in the queue at

their scheduled times, and the queues will be processed and jobs in each queue will be run on a first-come

first-serve basis. It is also possible to manually add jobs to the queue without using the Backup

Administrator interface. To add a job to the queue, refer to the stqueue command in the Commands

Reference Guide.

Running a Backup Job from the Command Line

It is possible to run a backup job from the command line, bypassing the job queues, by using the strunjob

command (refer to the strunjob command in the Commands Reference Guide). The SBAdmin Interface

need not be running. Note that the job will start immediately and may interfere with other jobs writing to the

same devices since the queues are not used. If you wish to add the job to the queue from the command

line, so that it will run only when the TSM server is available, refer to the section

Adding a Job to the Queue

from the Command Line.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 116 117

Keine Kommentare

Storix-software SBAdmin TSM Edition Users Guide Bedienungsanleitung Seite 47